CJQXB - LITE WEIGHT 3 - LIGHTWEIGHT BODYFILLER, 164
- MSDS: CJQXB
- Manufacturer: FIBRE GLASS EVERCOAT CO INC
- Product Name: LITE WEIGHT 3 - LIGHTWEIGHT BODYFILLER, 164
- National Stock Number: -
Product Identification
Product ID:LITE WEIGHT 3 - LIGHTWEIGHT BODYFILLER, 164
MSDS Date:01/01/1999
FSC:NIIN:Submitter:N EN
Status Code:A
MSDS Number: CJQXB
Responsible Party
CINCINNATI, OH 45242-2033
US
Emergency Phone: (800)424-9300
Info Phone: 513-489-7600
Cage: 18731
Contractor
Telephone: 513-489-7600
Cage: 18731
Ingredients
4.50 MMHG
CAS: 1317-65-3
RTECS: EV9580000
OSHA PEL 15 MG/M3
ACGIH TLV: 10 MG/M3
EPA Report Quantity: 1000 LBS
DOT Report Quantity: 1000 LBS
Hazards
Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:YES OSHA:NO
Health Hazards Acute and Chronic:ACUTE: EYES: CONTACT W/LIQUID OR VAP
MAY RESULT IN IRRIT, REDNESS, TEARING & BLURRED VISION. SKIN:
CONTACT W/WET MATL MAY RESULT IN IRRIT OF SKIN & POSSIBLE DERM.
INHAL: EXCESSIVE INHAL OF VAPS MAY CA USE NASAL & RESP IRRIT, ACUTE
NERVOUS SYSTEM DEPRESSION, FATIGUE, WEAKNESS, NAUS, HDCH & DIZZ.
INGEST: INGEST OF THIS MATL MAY CAUSE GI IRRIT, NAUS, DIARRHEA &
VOMITING. ASPIRATION OF MATL INTO LUNGS DUE TO VOMITING MAY
PRODUCE CHEMICAL PNEUMONITIS WHICH CAN BE FATAL. CHRONIC: EXCESSIVE
OVEREXP TO STYRENE HAS BEEN FOUND TO CAUSE THE FOLLOWING EFTS IN
LAB ANIMALS: LIVER ABNORMS, KIDNEY DMG & LUNG D MG. (SEE ALSO OTHER
INFO SECTION.)
Explanation of Carcinogenicity:STYRENE: IARC MONOGRAPHS, VOL 60, PG
233, 1994: GROUP 2B.
Effects of Overexposure:SEE HEALTH HAZARDS.
First Aid
First Aid:EYES: FLUSH IMMEDIATELY WITH LARGE AMOUNTS OF WATER FOR AT
LEAST 15 MINUTES. SEE PHYSICIAN FOR MEDICAL TREATMENT. SKIN:
IMMEDIATELY WASH AFFECTED AREA WITH SOAP AND WATER. REMOVE
CONTAMINATED CLOTHING . CONSULT PHYSICIAN IF IRRITATION DEVELOPS.
INHALATION: REMOVE PERSON TO FRESH AIR. RESTORE BREATHING. KEEP
PERSON WARM AND QUIET. TREAT SYMPTOMATICALLY. GET MEDICAL
ATTENTION. INGESTION: KEEP PERSON WARM AND QUIET. CONSULT A
PHYSICIAN OR POISON CONTROL CENTER IMMEDIATELY.
Fire Fighting
Flash Point:=36.1C, 97.F
Lower Limits:1.1%
Extinguishing Media:FOAM, CARBON DIOXIDE AND DRY CHEMICAL.
Fire Fighting Procedures:USE NIOSH APPROVED SCBA AND FULL PROTECTIVE
EQUIPMENT . WATER MAY BE USED TO COOL CONTAINERS TO PREVENT
PRESSURE BUILD-UP WHICH MAY RUPTURE CONTAINERS.
Unusual Fire/Explosion Hazard:VAPORS ARE HEAVIER THAN AIR AND MAY
TRAVEL ALONG THE FLOOR AND BE IGNITED BY SPARKS OR FLAMES AT A
DISTANCE FROM WHERE THE MATERIAL IS BEING USED.
Accidental Release
Spill Release Procedures:REMOVE ALL SOURCES OF IGNITION. VENTILATE THE
AREA. WEAR PROTECTIVE EQUIPMENT (SEE SPECIAL PROTECTION
INFORMATION). AVOID BREATHING VAPORS. CONTAIN SPILL. COLLECT WITH
INERT ABSORBENT AND REMOVE. DISP OSE OF PROPERLY.
Handling
Handling and Storage Precautions:STORE MATERIAL IN A COOL,
WELL-VENTILATED AREA. DO NOT STORE AT TEMPERATURES ABOVE 75F. DO
NOT STORE NEAR HEAT, SPARKS OR OPEN FLAME. KEEP CONTAINERS TIGHTLY
CLOSED. AVOID CONTACT WITH INCOMPATIBLE MA TERIALS.
Other Precautions:THIS PRODUCT MUST BE MIXED W/CATALYST PRIOR TO USE.
PLEASE REFER TO MSDS FOR CATALYST BEFORE USING. IF PRODUCT IS TO BE
SANDED, THE PEL/TLV OF 10 MG/M3 FOR NUISANCE DUSTS SHOULD BE
OBSERVED. KEEP OUT OF REACH OF CHILDREN. DO NOT TAKE INTERNALLY.
AVOID CONTACT WITH EYES & SKIN.
Exposure Controls
Respiratory Protection:USE NIOSH APPROVED RESPIRATORS DESIGNED TO
REMOVE PARTICULATE MATTER AND ORGANIC SOLVENT VAPORS.
Ventilation:GENERAL DILUTION OR LOCAL EXHAUST VENT SHOULD BE PROVIDED
TO KEEP EXPOS BELOW ACCEPTABLE LIMS & TO KEEP SOLVENT VAPS BELOW
LOWER EXPLOSION LIMIT.
Protective Gloves:NEOPRENE OR NATURAL RUBBER.
Eye Protection:ANSI APPROVED CHEMICAL WORKERS GOGGLES .
Other Protective Equipment:ANSI APPROD EYE WASH & DELUGE SHOWER . PROT
GLOVES & PROPER CLTHG SHOULD BE WORN TO PVNT SKIN CONTACT. BARRIER
CREAM MAY BE WORN FOR ADDNL SKIN PROTECTION. IMPERMEABLE CLTHG
SHOULD BE (SUPDAT)
Work Hygienic Practices:ALWAYS WASH HANDS AFTER USING THIS MATERIAL,
AND BEFORE EATING, DRINKING OR SMOKING.
Supplemental Safety and Health
OTHER PROT EQUIP: WORN TO PVNT PRLNGD/RPTD CONTACT OF WET MATL WITH THE
SKIN. PHYSICAL DATA - WEIGHT PER GALLON: 9.95 LBS/GAL.
Chemical Properties
Boiling Pt:=145.C, 293.F
Vapor Pres:SEE INGREDIENTS
Vapor Density:HVR/AIR
Spec Gravity:1.19
Evaporation Rate & Reference:SLOWER THAN ETHYL ETHER
Stability
Stability Indicator/Materials to Avoid:YES
PEROXIDES, STRONG OXIDIZERS, STRONG MINERAL ACIDS AND POLYMERIZATION
CATALYSTS.
Stability Condition to Avoid:HIGH TEMPERATURES, IGNITION SOURCES, AND
CONTACT WITH INCOMPATIBLE MATERIALS.
Hazardous Decomposition Products:FUMES MAY BE PRODUCED WHEN MATERIAL IS
HEATED TO DECOMPOSITION. FUMES MAY CONTAIN CARBON MONOXIDE, CARBON
DIOXIDE, AND VARIOUS HYDROCARBONS.
Disposal
Waste Disposal Methods:DISPOSE OF I/A/W FED, STATE & LOCAL REGS. WASTE
FROM THIS PROD MAY BE HAZARDOUS AS DEFINED UNDER THE RESOURCE
CONSERVATION & RECOVERY ACT (RCRA) 40 CFR 261. WASTE MUST BE TESTED
FOR IGNITABILITY TO DE TERMINE THE APPLIC EPA HAZARDOUS WASTE
NUMBERS. BEFORE ATTEMPTING CLEAN-UP OR DISPOSING OF MATL, REF ER TO
HAZ INFO IN OTHER SECTIONS OF THIS SHEET.
Other Information
Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.
Regulatory
SARA Title III Information:STYRENE IS SUBJECT TO REPORTING REQUIREMENTS
UNDER SARA TITLE III, PART 313.
State Regulatory Information:WARNING: THIS PRODUCT CONTAINS A CHEMICAL
KNOWN TO THE STATE OF CALIFORNIA TO CAUSE CANCER.